It pays to check your work. I have reached a new level of experience in distributing patterns shafts. I know how to do it backwards and forwards now. Literally. Unfortunately, I moved almost all of the pattern shafts before noticing that the spacing between units is not quite right. Uh oh! So, one by one, I reversed the distribution of pattern shafts to get back to the point of error—the very beginning. The reverse move was …more complicated.
Distribution of pattern shafts is part of the setup for the drawloom. It is a multi-step process that moves the pattern shafts, one at a time, from the heddle bar at the back of the loom to the pattern shaft holders just behind the ground shafts at the front of the loom. Sound complicated? It’s not that hard, and is fun to do after you’ve done it a few times.
Lesson learned:Check my work. I am off by only one unit of threads. That small miss, however, is enough to sabotage the whole project if not corrected. The sooner I check my work against the master plan the better. Fortunately, everything at the loom is fixable. It’s never too late to start again.
First, I use an old inkle band to slip between heddles that I am separating to transfer to a pattern shaft. Because I am using a combination of pattern shafts AND single units, I separate the heddles on the “front” side. If I were usining only pattern shafts and no single units, I could separate the heddles from the back while standing behind the loom.I insert a pattern shaft through the separated pattern heddles. Then I remove the inkle band and hang it around my neck, ready for the next transfer.I slip the waiting heddle bar through the pattern shafts that have not been separated……and remove the first heddle bar. This releases the separated pattern heddles onto the pattern shaft, which is hanging in a pair of holding cords. From here, the pattern shaft is moved forward to the pattern shaft holders. (I also adjust the clip overhead that connects the thread unit to a single unit draw cord.)After backtracking and starting over, I now diligently check the number and spacing of units on the heddle bar after every pattern shaft is moved into position. Success!Twelve pattern shafts, plus one X shaft. This project uses pattern shafts for the borders only – top, bottom, and sides. The rest of the pattern areas will use single-unit designs.
The sooner I check my life against God’s master plan the better. Fortunately, everything is forgivable. It’s never too late to start again.
All set and ready to go! Everything works. After a bit more testing of weft colors and patterns, it’s critter time. Watch for Mr. Armadillo first!
May you check for accuracy sooner than later.
Be blessed, Karen
3 thoughts on “Check for Accuracy Now or Backtrack Later”
Hi Karen,
This goes over my head, with a touch of Greek thrown in but I do find it interesting. I will never own this loom or attachment due to space, time and money, however, it is fascinating to see you set it up and what is created.
Thanks for taking the time to share your photos.
Maureen
Hi Karen,
This goes over my head, with a touch of Greek thrown in but I do find it interesting. I will never own this loom or attachment due to space, time and money, however, it is fascinating to see you set it up and what is created.
Thanks for taking the time to share your photos.
Maureen
Hi Maureen, Thank you for your interest. I know it’s an unusual loom. It’s something I never dreamed I would do, but here I am enjoying the ride.
Thanks,
Karen
Can’t wait to see the critters!