If a Warp End Is Frayed…

I noticed that a warp end was starting to fray, but I kept on weaving. I thought I could make it past the weak spot. Well, I was wrong. The warp end broke. So much for happy weaving! A broken warp end at the selvedge is no fun, especially on a weft-faced piece like this. Looking back, I wish I had taken time to splice in a new length of thread when I first noticed the weakness. But at the time, I didn’t want to be bothered with that. I just wanted to weave.

Tapestry / inlay sampler on small countermarch loom.
Weaving right along. I start to notice some abrasion on the warp end at the right selvedge. I’ll be extra careful. I can keep weaving and enjoy myself, right???
Broken selvedge end on the right. Ugh.
Warp end on the right selvedge frayed to the breaking point. Gone! The weaving must be removed far enough back to reach at least 1/2″ of the warp end in front of the break. That reaches back into the red portion–the first section of the sampler.
Tapestry / inlay sampler on small countermarch loom.
Pin is inserted to secure a new selvedge warp end. The fourth end from the right showed some fraying, so I am splicing in a new piece of 12/9 cotton warp. Learned my lesson.
Original selvedge warp end is now being spliced back in (green flathead pin). Second splice is complete, with thread tail hanging out, to be trimmed after this is off the loom.
Tapestry and inlay sampler. Spliced warp ends fix frayed threads.
Two sections of the tapestry and inlay sampler are complete.

We tell ourselves if we do what we want, we will be happy. That’s a delusion. Happiness will fail you. It doesn’t last. I was only happy weaving until the thread broke. There is something better than happiness. Faithfulness. It’s better to be faithful in the moment, even if it puts a delay on being happy. Faithfulness lasts. Next time, I hope to choose the long satisfaction of faithfulness over the short-lived gain of happiness.

May your broken selvedge ends be few.

Faithful weaving,
Karen