Tools Day: Texsolv Secrets

I am upgrading my “baby loom” from four shafts to six shafts. My woodworker husband fashioned the new pieces for this 100 cm / 39″ Glimakra Ideal countermarch loom. Since I need to add new Texsolv cords to the two new pairs of shafts and accompanying horizontal jacks, I decided to replace the thirty-year-old cords that are on the original pieces at the same time.

Tips for preparing Texsolv cord.
Measuring, marking, and cutting Texsolv cord for new six-shaft shaft holders. Tools, from top to bottom: Cord threader, rotary cutter, black Sharpie, Thread Zapp II.

Tools:

  • Spool of Texsolv cord
  • Rotary cutter with sharp blade, and cutting mat; or, sharp scissors
  • Permanent marker
  • Cordless thread zapper (I got my Thread Zap II at Hobby Lobby)
  • Cord threader (Steve made mine; GlimakraUSA carries a similar one)
Adding new Texsolv cord to updated countermarch loom. Texsolv tips.
Upgrade to six shafts from four meant adding two pairs of shaft bars, two upper lamms, and two lower lamms, plus expanding the jacks at the top of the loom. New Texsolv cord was measured, marked, and cut the same for all six shafts. The cords seen on the lower shaft bars connect to the center hole in the upper (shorter) lamms when the loom is tied up.
Top of Glimakra Ideal horizontal countermarch.
Viewed from above, the horizontal countermarch now has 8-shaft capability. Steve guessed I might eventually want a total of eight shafts, and decided to get the hard part out of the way now. The six jacks in use are connected via a long center Texsolv cord to the lower lamms below when the loom is tied up. The outer ends of the jacks in view have cords that connect to the top shaft bars. Countermarch is a nifty mechanism. Simple, really.

Texsolv Tips:

  • Measure length of Texsolv cord. “Measure twice; cut once.”
  • Cut with very sharp blade on the “line” between holes. A sharp blade reduces the cord’s tendency to fray apart when cut.
  • Use thread zapper tool to melt the cut ends. Roll melted end between fingers to form a firm tip at the cut end.
  • Especially for countermarch looms: This one tip greatly simplifies countermarch loom tie-ups because it eliminates guessing about getting everything even. Use permanent marker to make consistent marks on like cords, to enable even tie-ups; e.g., with the marker, put a mark on the second hole from the top, and on four holes (alternate with unmarked holes) near the bottom end of shaft-to-lamm cord, so that when you attach shafts to lamms, all the cords can be precisely aligned. (All my cords are measured and marked. I keep one of each marked cord in a labeled Baggie as a sample to make it easy to replace or add any cord.)
  • Use threader, if needed, to thread cord through holes in the loom parts.

Quiet Friday: Cutest Loom Ever is a look back to the first renovation this little old loom experienced.

May you find new ways to do old things.

Getting ready,
Karen