In My Drawloom World

I’m in my own little world when I’m at the drawloom. No podcasts, no music going, no interruptions. It’s all deliberate focused attention on this thing I’m doing—following the chart row by row, drawing handles and cords, imprinting trees into cloth. It’s a delightful experience that I don’t want to end.

Myrehed combination drawloom. Weaving trees.
Single unit draw cords pull up single units of threads. For the setup on this project one unit is 6 ends.
Weaving trees on the drawloom.
Trees inside and outside.

The simple tree design is scattered across the fabric using the single unit draw system. At the start of this towel, the same tree design was woven on the side borders using the pattern shafts. With this combination drawloom I combine single units and pattern shafts to work in complex harmony, as an expression of my creativity.

Myrehed Combination Drawloom on a Glimakra CM loom.
Trees on the side borders, as seen on the cloth below the breast beam, were woven using pattern shafts. Each pattern shaft holds units of ends in a certain order, which enables me to duplicate patterns across the warp or on the sides, as with these trees.
Weaving hand towels on the drawloom.
Near the finishing line for this towel.
Myrehed Combination Drawloom - follow the chart.
Clear ruler moves up the chart, line by line, showing me exactly which black or white single unit cords to draw. The checked borders are produced with the pattern shaft draw handles.

The Lord is ready to give us his focused attention. Our complexity is no threat to him. When we allow him to direct our hearts, pulling cords at the right place to imprint his will in us, he faithfully completes the work, to the very last detail. The Lord embraces those who fully trust him. His unseen designs become visible in the lives of those who belong to him. We can just imagine the delight this brings to our Maker.

May you find yourself in a big hug.

Happy Weaving,
Karen

Tried and True: What a Little Piece of Tape Can Do

You never know when you’ll need a piece of blue tape. A roll of blue painter’s tape is among my essential weaving supplies. My favorite way to temporarily mark just about anything is with a piece of blue tape.

Blue Painters Tape for Temporary Markings

  1. Cut (or tear) the tape to size.
  2. Fold one edge of the tape under. This makes a little tab so that the tape is easy to remove or reposition.
  3. Use a fine point Sharpie to write on the tape.
Weaver's uses for blue painter's tape.
Tape prepared for pointing.

Three Examples

  • Keep your place. Draw an arrow on a small piece of blue tape. Use the arrow on the tape to follow along the threading or treadling draft. This eliminates confusion, especially after a pause.
Blue tape uses in the weaving studio.
Rosepath treadling for 4-shaft tapestry. Since there are plain weave picks between each rosepath row, I need something to remind me where I left off.

  • Measure the space. Draw a straight line on small pieces of tape. Measure the warp width on a tapestry frame or rigid heddle loom. Use the lines on the tape to mark where the first and last warp ends should lie on the loom. This eliminates guessing when warping the loom.
Uses for blue tape in my weaving studio.
Tapestry frame is ready for a new warp. After measuring for weaving width, and counting dents, I mark the dents with tape. No more guessing if I’m “almost there” when putting on the warp.
Blue tape to mark the rigid heddle. And other uses for blue tape.
By clearly marking the first and last slots/holes I can verify that my calculations are correct before I start warping the rigid heddle loom. This is helpful for direct warping and for indirect warping methods.

  • Number with Grace. Write out a series of numbers on a long piece of tape, leaving space between the numbers. Cut the numbers apart. Use the numbers to label pattern shaft draw handles on the drawloom. Place the numbers directly above the draw handles, arranged in groups of five for easy visual recognition. Use a separate series of numbers for border pattern shafts, if applicable. This temporary numbering system gives the advantage of being able to customize the numbering for each drawloom draft.
This is how I number my drawloom handles. Blue tape!
Using the Myrehed Combination Drawloom, I configure the numbers for the pattern shaft draw handles to coordinate with the single unit draw cords, which are grouped by tens. This makes my working chart that uses single units and pattern shafts much less complicated. For this reason, it doesn’t make sense to give my draw handles “permanent” numbers.

Have you found ways to use blue painter’s tape in your weaving studio? Share in the comments!

May your life leave marks that are more than temporary.

Have fun,
Karen

Be Weave-Able

I call her the ”Rain Girl.” She comes from an illustration in a very old children’s book on our bookshelf. The small tapestry is cute. But with its many slits and single warp wrappings, it falls short of what it could be. I compromised best practices to make it work.

New small tapestry - Rain Girl.
Small tapestry gets its start on a camping trip. Paint stir stick holds the cartoon in place under the warp.
Weaving a small tapestry from the back.
Weaving from the back. Long car rides are good for portable tapestry weaving.
Cartoon is not going to work for this small tapestry.
Checking the cartoon again.
Small tapestry almost finished. Rain Girl.
Finishing up the weaving of Rain Girl just before pulling back into our driveway after a long trip.

The main fault is with the cartoon. It isn’t weave-able. The image is too small for this sett. There must be a better way to weave this image.

Mounting a small tapestry on foam core board covered with flannel and linen.
Hems are stitched down. 1/2″ foam core board is covered with a layer of cotton flannel, and then natural colored linen.
Mounted small tapestry. Rain Girl.
Rain Girl, first version.

I am starting over with a whole new cartoon! I have now learned that Affinity Designer (computer graphics software) gives me the ability to create vertical parallel lines equivalent to my sett. With those lines in view I can see exactly how each part of the cartoon fits the warp spacing. I am turning the image on its side and enlarging it, and then, cropping to size. This cartoon is going to be weave-able.

Affinity Designer to create a new tapestry cartoon.
Screen shot from Affinity Designer. Image from book illustration is positioned on its side, enlarged, and cropped. View shows vertical lines that match the sett for the tapestry.
Creating a new tapestry cartoon in Affinity Designer.
New Rain Girl cartoon is ready for printing.

All of us have gone our own way. We insistently follow our own cartoon, compromising best practices, while struggling to make it work. There is a better way. Jesus Christ gave himself so that the Grand Weaver’s cartoon could be written on our hearts. In his hands we become his beloved tapestry. Be weave-able.

May your cartoon be just right.

Hopeful,
Karen

Process Review: Glimåkra Siru – First Time Around the Block

This is the completion of my first warp of three shaft twill on a rigid heddle loom. One step beyond plain weave, this opens the door to further exploration of double-heddle weaving on the rigid heddle loom. I already have two 50 cm (12-dent) heddles in hand for my next project, which will enable me to get an even finer/tighter cloth than with the 40 cm (10-dent) heddles I used for this project.

Guadalupe Mountains National Park and weaving outside.
Glimåkra Siru rigid heddle loom, beside the Weber grill on the picnic table. Weaving outside in Guadalupe Mountains National Park, Texas.
Cottolin warp, and cottolin and linen wefts, make lightweight, but sturdy colorful face cloths. 1/2 weft-faced twill.

The Glimåkra Siru Rigid Heddle loom is the star of this show. Follow along as I take a quick look back through the process of weaving this light fabric. The cotton and linen squares are perfect for face cloths and light wash cloths.

May you be blessed.

Happy Weaving,
Karen

Picture Perfect Handwoven Skirt

The skirt in my mind is picture perfect in style and fit. If I could snap my fingers and make the skirt appear, I would. Instead, I find my way to a workable sewing pattern by trial and error—agonizing over every small step. The sewing part doesn’t scare me. But I’m in over my head in the garment design arena.

Using Garment Designer to design a layered tiered skirt.
Quarter-scale pattern pieces give me a way to test and try various ways to put the skirt together. I learn a lot of things that don’t work. There is much sewing, ripping, tweaking, calculating and recalculating, etc. And pulling my hair out, figuratively speaking.
Designing a handwoven skirt using Garment Designer software.
Settling on something that works. One more little mockup should answer most remaining questions. I use Garment Designer (patterning and design software) to create the patterns. I can print quarter-scale and full-scale sewing patterns.

A not-as-simple layered tiered skirt replaces my original idea of a simple three-tiered skirt. The new design has a fitted yoke at the top of the skirt (and a zipper) instead of a super-simple elastic gathered waist. All this, so the distinctive borders of each tier will flutter freely, and not be trapped in seams. The trouble is worth it. I can see the finished skirt in my mind’s eye. It is phenomenal! The fabric is handwoven, made for a purpose. This is a skirt worth waiting for.

Testing ideas for a handwoven skirt.
Testing ideas full scale. After several tries, I finally have a good fit on the skirt yoke, which is encouraging.
Handwoven skirt in the making!
Full-size mockup (not shown) satisfies my fit and style requirements. Floral cotton lining fabric will be concealed under the handwoven tiers. Full-scale sewing pattern is printed and ready…

You were skillfully made for a purpose. Through many trials and errors, lessons in success and failure, we discover why we are here. God created you for this very time. Trust him to guide you, especially through agonizing moments. By his grace, he forms us into the phenomenal masterpiece that he has always had in mind.

May you walk with purpose.

Love,
Karen