Tag: Glimakra

Cloth Beam Matters

Karen

Does it matter what happens at the cloth beam? Why not let the woven fabric go around the beam as is and forget about it? You have worked diligently at every stage to ensure an even warp. Now, preparing the cloth beam for cloth will ensure the warp remains even.

Warping slats are placed on the cloth beam.
Warping slats cover the cords and knots on the cloth beam so the handwoven fabric has a flat surface to lay against.
Warping slat over the tie-on bar prevents the tie-on threads from putting bulges in the fabric. Bulges can distort the fabric and put uneven tension on warp ends.
Warping slats around the cloth beam for a smooth start.
When the warping slats have covered one full revolution of the cloth beam, no more slats are needed. The twill pre-measured tape on the floor gives a clue to the extended length of this table runner on the loom.

The cloth beam holds obstacles that threaten the evenness of your warp. Any raised surface on the beam, like beam cords and tie-on knots, will distort the warp tension as the woven fabric wraps around it. Warping slats solve the problem. I lay in the slats around the beam, one by one, as I advance the warp. This forms a flat surface around which my freshly-woven fabric can hug as the cloth beam turns.

M's and O's long table runner. Linen weft.
Long M’s and O’s table runner on the loom. The sample piece and towel that preceded the table runner have already reached the cloth beam.

Fear makes obstacles for our path that disturb our peace and threaten our well-being. Trust in the Lord. Trust pushes fear aside. The day you are afraid–the moment you are afraid–put your trust in God. Know that the Lord is for you. Your trust in Him forms a firm layer to build your life on. Like the warping slats that are in place for your handwoven cloth, your trust in God is a foundation on which to roll the fabric of your life.

May you walk without fear.

Peace,
Karen

Finer Weft for a Stronger Cord

Karen

I need a strong cord for a specific use. It needs to look nice, without drawing attention to itself. This cord will connect three small pieces of wood. I will reveal how they will be used after I finish weaving the cord.

Three wooden pieces for a special purpose...
Three wooden pieces to be connected for a purpose. What are they for? You are welcome to put your guess in the comments…
Warping the Glimakra band loom.
Warping the band loom.

I chose 12/6 rug warp for the project, to make this a durable cord. With a band this narrow, the 12/6 cotton is too bulky for weft. I could not pull the selvedges tight. I need a finer weft that will draw the warp ends together and disappear at the selvedges. Black 16/1 linen works beautifully!

New woven narrow band. Need to change the weft.
Using 12/6 cotton rug warp for the weft proved to be unworkable for this narrow band. Light shows through the gaps at the selvedges.
Linen weft for this narrow band.
Black linen weft matches the black selvedge threads. The 16/1 linen enables tight and even selvedges for this 5/16″ (8 mm) band.

A change of heart changes everything. The condition of our heart is revealed in the way we behave toward others. Our thoughts and actions are a matter of the heart. To live in a manner that is unselfish, generous, kind, and content, we must do more than line up the right outward appearances. We must start with humility. Having the perfect warp means nothing if the weft interferes with a beautiful outcome. Humility, like the linen weft, is a posture of the heart that pulls everything else together.

May your heart be beautiful.

Warmly,
Karen

Linen Is Never Boring

Karen

Simplicity, purity, new. It’s invigorating to start something fresh. Weaving this delicate cloth in neutral colors is calming, but not boring. The linen sheen makes it spectacular. This is the delightful texture of M’s and O’s on a cotton warp, with linen weft. Peer across the cloth at a lower angle and you will see the linen’s pearlescent glory embedded in the woven texture.

Weaving M's and O's with linen weft.
Structure of M’s and O’s puts interesting texture in the fabric. The texture will be intensified after the fabric is cut from the loom and wet finished.

Even though weaving seems like magic at this stage, it has been preceded by a lot of planning, precision, and patient work. This new creation is refreshing because it’s everything I had imagined it would be. And the linen is doing as expected–making the fabric “glow.”

Handwoven towel in M's and O's with linen weft.
One-shuttle weaving for most of the towel makes this a relaxing weave. You can see that the treadling pattern alternates between two blocks. (The camera doesn’t catch the linen’s sheen like the human eye does. Wish you were here to see it!)
Handwoven towel in M's and O's.
Towel has reached the midway point.

The best creation is what happens inside of you. There is hope for all those who long for a fresh start. The dusty and worn threads are replaced with a new warp. Cut my selfish ways off the loom, Lord. All the preparations have been done by the Grand Weaver that enable weaving to begin. Create a clean heart in me, Lord. Let my life glow with the linen of your Spirit woven through my soul.

May you be refreshed.

Love,
Karen

~They’re back~ Towel Kits ~

By request, I have put the towel kits back in my shop! The River Stripe Towel Set, Pre-Wound Warp and Instructional Kit, for $150 per kit, is now listed again in the Warped for Good Etsy Shop. Happy weaving!

Tools Day: Reeds

Karen

Eventually, I would like to have a metric reed (or two) in every possible size. Until then, I will be happy with what I have, while I gradually add to my supply, as needed, one reed at a time.

I prefer metric reeds (dents per 10 centimeters) over imperial reeds (dents per inch). For one thing, the math is easier for project planning. And because there are smaller increments between sizes, there are more sett choices with metric reeds. It could be my imagination, but it often seems that the metric reed yields a Goldilocks “just right” sett.

Assortment of weaving reeds.
Supply of reeds. Some purchased new, some second-hand purchases, and some received as gifts. All but one have been used on my looms. The reeds usually reside in my weaving supply closet.

My selection of reeds vary in length, from 70 cm (27″) to 120 cm (47″), to fit the weaving widths of my looms. But Glimåkra countermarch looms have beaters that are open on the sides, so I can use any length reed in any loom.

Beginning cotton warp with M's and O's.
Reed with 120 cm weaving width is being used on this 100 cm Glimåkra Ideal. This is a 22.5 dents/inch reed, sleyed two ends per dent. Notice that the warp is high in the reed? That’s because the front tie-on bar is going over the breast beam.

My all-around favorite reeds are those made by Glimåkra because they are lightweight and easy to handle, …and they come in metric sizes. (Of course, you need to choose reeds that work with your loom.)

Taqueté in Tencel on eight shafts.
This 120 cm reed is a perfect fit for the weaving width of the 120 cm Glimåkra Standard loom. This is a 50/10 metric reed, giving a Goldilocks “just right” sett for this 8/2 tencel taqueté.

I put together a reed conversion chart so that we can see our options at a glance. You never know when a new project will “require” a new metric reed!

Weaving reed metric/imperial conversion chart.

May your next project have a Goldilocks “just right” sett.

Happy weaving,
Karen

Keep Threading Those Heddles

Karen

It will be worth it. 896 threads through these heddles, and then two ends per dent in the reed. This is the necessary dressing of the loom. I do it nine minutes, thirty-five minutes, and twenty-two minutes at a time. I do not accomplish it in one sitting. After accumulating almost five hours of threading, I’m ready to sley the reed.

Threading heddles.
Colored threads are 16/2 cotton, thicker than the 24/2 unbleached cotton threads.
Threading Heddles
Checking for threading errors before tying the group of ends into a loose slip knot.

It is easy to lose concentration when there are so many ends. The M’s and O’s threading has just enough variation in it to make me wonder if I did keep it all in the correct sequence. We will find out. The threading, correct or not, is always revealed as the fabric is woven.

Texsolv heddles of four shafts. Glimåkra Ideal.
Texsolv heddles on four shafts, threaded. Glimåkra Ideal.
Sley the reed. Glimåkra Ideal.
Two ends per dent are sleyed in this 22.5-dent-per-inch reed.

What is faith? Faith is putting your trust in something you have good reason to think is true. Stand firm, immovable, in your trust in the Lord. You put threads in the heddles because you have good reason to think these threads will become fabric. Don’t quit. Keep coming back to it. Be strong in faith. And do it from a framework of love. Your framework is always revealed in the cloth of your life.

May you stay strong.

Happy threading,
Karen