Category: combination drawloom

Tried and True: Just in Case

Karen

Texsolv cord is ingenious! It suspends shaft holders while I dress the loom. It also suspends the heddling bar during drawloom setup. A small anchor pin or arrow peg does the trick of holding everything together.

How to use Texsolv cord and anchor pins.
Anchor pin is buttoned through the Texsolv cord and placed into the hole at the bottom of the shaft holder.
Talking about Texsolv cord and arrow pins.
Thread one end of the Texsolv cord through a hole in the other end to make a loop. Insert an arrow peg through a hole to secure the loop.

But there is one potential hazard…

In order to adjust the height of the suspended heddling bar at the drawloom, I want to move the arrow peg. I hold one end of the bar while pulling the peg out of the Texsolv cord. That little peg fumbles out of my hand and drops to the floor. OOPS! I am left holding one end of the bar that has 148 threaded pattern heddles, weights included. Now what?! Alone in the room, I am now the sole support for that end of the heavy bar. The peg on the floor is out of reach.

Super Simple Tip of the Day

Always keep a spare anchor pin or arrow peg on the loose end of the Texsolv cord. Always.

Just in Case strategies.
Spare anchor pin stays on the shaft-holder cord. You do not want to be left holding a shaft holder with eight shafts if your anchor pin ever falls out of your hand…

The rest of the story…
When that pesky little arrow peg slips out of my hand I calmly take the spare peg that is there “just in case,” and secure the Texsolv loop that holds the heddling bar. No big deal, after all.

Strategies for Just in Case!
Spare arrow peg dangles below. Whew!
Tips for just in case!
Spare arrow peg is a life saver on the rare occasion it is needed. There is a significant amount of weight on that heddling bar.

May you be ready for anything, just in case.

Ready or not,
Karen

Sneak Out to the Drawloom

Karen

Two of my looms are getting the lion’s share of my attention right now. That doesn’t keep me from sneaking out to the drawloom, though, for an hour here, an hour there. Those hours add up. I have everything threaded and sleyed. The reed is in the beater now, and I’m tying on the warp.

Six ground shafts on the drawloom. Threading.
Pattern heddles have been threaded. Ground heddles are being threaded. 888 16/2 cotton ends on six ground shafts.
Getting ready to tie on the warp on the combo drawloom.
Moving the reed and threaded ground shafts to the front of the loom is tricky. Having a second pair of hands (Steve’s) definitely helps.

148 single unit lift heddles and 45 pattern shafts are waiting in the wings. I’m setting up the combination drawloom again for maximum flexibility in designing. That also means I’ll have abundant possibilities for weaving. Oh, what exuberant escapades await! This anticipation keeps me skipping down the path of preparation, ever so steadily, as I dream of entering that magical world of drawloom weaving once again.

Getting the drawloom ready to weave.
I like to tie all the ends into small sections (about 1 inch at the reed) first. Then I tie them on the front tie-on bar, starting right of center, and then alternate left, right, and so on.

There is a door into an invisible kingdom. You may have seen it as a child. The door to God’s invisible kingdom is open. With childlike trust we give our heart to Jesus and his kingdom comes alive. In the here and now, as our preparation continues, we are ever mindful of the abundant existence of the ever after. What exuberance awaits!

May you see like a child.

Happy Weaving,
Karen

Process Review: Drawloom Preliminaries

Karen

I threaded 888 warp ends. I am getting ready to thread those 888 ends again. It’s part of the preliminary process for a new drawloom project. A drawloom has two sets of heddles. Thread the pattern heddles. Then, thread the ground heddles. I enjoy all the preliminaries because of what they bring about—a delightful new weaving adventure!

Preparing a new drawloom warp.
New drawloom warp of 16/2 cotton is on the warp beam.
Long heddles and lingos for the drawloom.
Long pattern heddles and lingos hang on a pegboard wall in the drawloom studio until needed.

Before I start threading, I count out all the lingos (weights) I need for the pattern heddles. Then, I hang a lingo on each unit of pattern heddles. In this case, there are 148 units, and six heddles in each unit. I move all those prepared units (heddles with lingos) to the back of the loom, get comfortable on my loom bench, and start threading. After a few sessions, I am finished threading the pattern heddles.

Drawloom threading heddles.
Pattern heddles hang at the back of the loom for threading.
Texas hill country Bluebonnets!
On the walking path to my drawloom studio each day I see the startling blooms of our Texas hill country Bluebonnets. Just imagine the unseen preliminaries for this beauty!
Drawloom pattern heddles and lingos.
Threading continues.
Pattern heddles are threaded for the drawloom.
All 888 pattern heddles are threaded! Ground heddles are next…

Next up, I will thread long-eye heddles on six ground shafts. A few more start-up operations after that, and then we will see this big ol’ boat raise its sails and leave the shore for another exhilarating adventure in weaving!

May you enjoy the preliminaries for every new start.

Happy weaving,
Karen

Process Review: Combination Drawloom as a Playground

Karen

Aside from the two taildragger banners, the sign for our guest powder room, and the Christmas snowflake hanging, these are test pieces and samples. The combination drawloom is a playground for design ideas. Test pieces and samples are not meant for display. I do want them to be seen on occasion, however. (See Time Lapse: Windmill and Taildragger on the Drawloom.)

Drawloom sign for the powder room.
This is a sign to hang in our guest powder room near a stack of handwoven hand towels.
Shaft drawloom snowflakes/stars.
Snowflakes on the drawloom.

In the September, 2004 issue of Complex Weavers Journal, Jette Vandermeiden wrote about weaving small serviettes to place between her good dishes so they don’t scratch each other. That sparked the idea for me to use my learning experience with the Myrehed combination drawloom attachment to make these small pieces of cloth. The various designs will bring delight as they are uncovered, one by one, when we set the table in our home with the good dishes.

Fun with the Myrehed combo drawloom.
Drawloom playground results using the Myrehed combination attachment.

Enjoy this review of the process of setting up and weaving on this playground.

May you have not-so-hidden treasures in your home.

Cheerful Weaving,
Karen

Unroll the Cloth Beam of 2020 – Year in Review Video

Karen

Every year my weaving journey is peppered with notable highlights. Here are seven such highlights from 2020: 1. Siblings Tapestry, complete and hanging in our living room. 2. Joanne Hall (my weaving mentor and friend) visited our home in February (while in Texas for her Swedish Art Weaves workshop). 3. New 8-shaft Glimakra Julia countermarch loom. 4. My favorite fabric of the year, Jämtlandsdräll in 6/2 Tuna, woven on the brand-new Julia. 5. Rag rugs woven on the drawloom. 6. Studio tour on Zoom for the San Antonio Handweaver’s Guild In November. 7. Handwoven Christmas tree skirt with Nativity appliqué from handwoven remnants.

Pictorial 4-shaft tapestry.
Last year began with completion of this Siblings tapestry.
Jamtlandsdrall on the Julia with 4 shafts.
Favorite cloth of the year. Jämtlandsdräll on the new Julia.

2021 is beginning with the start of a new pictorial tapestry, an empty loom waiting for a new warp, and a drawloom warp that is near its finish line. Plus, two other looms that are mid-project. I am not expecting any dull moments around here. Thank you for joining me in this ongoing adventure.

Four-shaft pictorial tapestry weaving.
Tapestry for the new year. I am starting with practice weaving for certain sections of the planned tapestry. You can see a pair of eyes on the cartoon under the warp threads.

Unroll the cloth beam with me and go back through time to recall the Warped for Good projects of 2020:

God completes what he begins. My prayer for you is that his finishing work will secure any loose ends.

May you see how far you’ve come.

Happy New Year, friends,
Karen