Category: wraps

Hemstitching Thread

Karen

Hemstitching gives a secure and pretty edge for the fringe on this cotton throw. At the beginning of the throw, I measure out a length of the weft thread for the stitching. And now, at the end, I roll off enough thread from the shuttle’s quill to use for the final hemstitching.

Finishing the cotton throw.
Wanting to finish, I weave the final few centimeters of the throw after dark.

Mark on tape shows I've woven to the end.
Mark on the measure tape shows I have woven to the end of the throw.

I’m always afraid of cutting the length of thread too short. So, I measure off four times the width of the warp, with a pinch extra just in case. That’s too long, and I know it. But I do it anyway. And then, I have a very long thread to pull through every stitch, with the tangles and knots that go with it.

Hemstitching is underway.
Hemstitching is underway.
Hemstitching a cotton throw.
Hemstitching thread is longer than needed. Three times the width of the warp should be plenty.

In trying to be perfect, I miss perfection by a long shot. If I measure out more than enough of my own goodness, surely I’ll have plenty to enter heaven, right? But the perfection of heaven requires perfection. It’s impossible for me to be good enough, smart enough, or successful enough to reach perfection. Heaven is for the imperfect. We, the imperfect, enter heaven’s perfection by trusting in the only perfect one, Jesus Christ. His goodness, measured out for us, is precisely enough.

May you know when enough is enough.

Happy weaving,
Karen

Weaving History Carries Memories – Year in Review Video

Karen

Transition. Changes. Adventure into the unknown. That describes 2018 for Steve and me. When I review my weaving history for the year, everything on the loom is attached to a memory. Like an old song that awakens our thoughts to past experiences, the Lizard tapestry certainly sparks in me revived memories of our transition season and the moving of looms. See Quiet Friday: Tapestry in Transition.

Removing the warp beam. Relocating the loom.
Steve unscrews a bolster that holds one side of the warp beam so I can remove the warp beam.

I began 2018 with a plan to weave coordinated fabrics for our Texas hill country home—towels, upholstery for bar stools, and placemats, explained in this post: Harmonized Weaving for the New Year. Accomplished! I also committed to weaving a gift for each of my three daughters (daughter and two son’s wives), as described in this post: Weaving a Gift. Accomplished two out of three! The final gift is nearing halfway on the loom right now.

Hemstitching at the beginning of the cotton throw.
Cotton throw has hemstitching at the beginning. The ends will be twisted for fringe when it’s taken from the loom.

Eight-shaft twill in an undulating pattern. Lightweight cotton throw.
Eight-shaft twill in an undulating pattern. Single-shuttle weaving gets me off to a fast start for 2019.

2019 is a continuation of transition, changes, and adventure, as we tiptoe into this retirement chapter. A drawloom is in the forecast, as well as some travel tapestry weaving, and more rag rugs, towels, scarves, and throws. And anything else we can think up. It’s going to be a good year! Thank you for coming along. I’m grateful to have you as a friend.

May you have much to look forward to.

Blessings to you,
Karen

Weaving Plans on Paper

Karen

I doubt myself when I start weaving something. But it’s a good time to question everything. The first twenty centimeters are designated for sampling. Is this the right sett? How is the weft density? What treadling order will I use? Which weft color(s) works best?

Trying out some treadling patterns.
Trying out some treadling patterns for this cotton throw. Undulating twill is planned.

It helps to see it on the loom. I plan on paper, and get excited when I see a ready warp on the warp beam. But nothing is settled until I’ve passed the sampling tests. The plan on paper is what I think I want. And then, unanticipated adjustments and changes are necessary at the loom. In the end, I expect the actual weaving to be better than my original plan.

Sampling before weaving a cotton throw.
More sampling of treadling patterns.

Testing weft colors for undulating twill cotton throw.
Testing weft colors.

When we think we must have what we planned, we give up a better way. We lose our way when we insist on having our way. Jesus came to us as an infant (the Christmas message), leaving his rightful heavenly position. To follow Jesus is to deny myself like he did. Some of the testing means telling myself no. In return, I gain the life I could not see on my paper plan.

May you give up some of your favorite plans.

With Advent thoughts,
Karen

Tied On and Tied Up

Karen

Our transition to Texas hill country is finalized this week! The looms and I will be residing in the same house again. Let the weaving resume! One loom is dressed and waiting for me. Tied on above, and tied up below. Ready to weave!

The warp is tied on to the front tie-on bar in 1-inch bundles, with 1/2-inch bundles at the selvedges. And then, I add the leveling string which makes it look neat and tidy and READY.

Leveling string flattens and evens out the warp for no-waste weaving.
Warp is tied on to the front tie-on bar. Leveling string flattens and evens out the warp for no-waste weaving.

The upper and lower lamms are positioned, and the treadle cords are added and secured. It’s fascinating how simple and basic the whole system is. And how something this simple and basic can be the framework for boundless creative expression.

Under the warp. Intriguing view.
I sit on the treadle beam when I position the lamms, and then place the treadle cords in their holes. I’m always intrigued by the view of the warp and heddles from this vantage point.

Treadle cords on eight shafts.
Treadle tie-ups don’t frighten me. It all makes sense, and is part of the loom-dressing process that I enjoy.

If we think of prayer as something that gets us out of a crisis, or words to say in order to get what we want from God, we miss the whole point of prayer. And we face disappointment. Prayer always works. The work is not our clever words, nor the checking off of our wish list. Prayer is the framework of deep trust that stands ready for the Lord’s boundless creative expression. We pray because we trust him. Christmas—the birth of Christ—shows us that God always steps in at the right time.

May your framework be sure.

Advent greetings,
Karen

Two Kinds of Dressing

Karen

Before everyone arrives for our Thanksgiving family gathering, I am making pie crust for the pecan pie, dough for my “famous” cranberry bread, and doing the prep to make Gram’s turkey dressing. Each family is bringing their contributions to the meal (feast). Thanksgiving Day is a flurry of activity with too many cooks in the kitchen—just how we like it! And sitting at the table with the feast before us, we give thanks. Thanks to each other, and to our Creator. We are blessed!

Making perfect pecan pie for Thanksgiving.
Thanksgiving feast prep. It takes two pastry chefs to make the perfect pecan pie.

And before everyone arrives I also manage to sley the reed on the Standard. A different kind of dressing—loom dressing.

Sleying the reed.
Two ends per dent in a 45/10 metric reed.

Sleying the reed.
I sit “inside” the loom on my loom bench to sley the reed.

Next step - tying on!
After the reed is sleyed, I remove the loom bench, lower the shafts, and move the countermarch to the front of the loom. Then, I place the reed in the beater and make sure it is centered. Next step–tying on!

Fresh warp on the back beam. Magical!
Getting dressed. Oh the beauty of a fresh warp going over the back beam! Magical.

A feast for the eyes and hands and heart. Thankful indeed!

May you give thanks,
Karen