Handweaver and 'cellist, married to Prince Charming, mother of three superheros and three superhero-in-loves, and Lola to nine little princes and princesses. Life is a handwoven treasure, filled with hidden melodies.
I am not fiddling with the weft fabric strips. Instead of making the right side of the fabric always show on top, I am letting the fabric strips fall as they may. The resulting variance in the weft gives the rug a vintage-like appearance. Also, I am using print fabric for some of the the light color of the double binding that purposely obscures the contrast of dark and light in some places. This is to give the rug a softer, more playful appearance.
Some of the red fabric for the rug’s hem has a wrong side that is much lighter than its right side. I am letting some of that lighter fabric show on top. Besides giving the rug a vintage-like appearance, this variance also makes the rug more reversible. The front and back side of the rug will be similar to each other, instead of one dark side and one light side.Glimåkra Ideal, with the beginning of a burst-of-color short rug to be used as a bath mat.
Home is where we make our true expression. The textiles from our hands speak without saying a word.
On the Road Again was a special challenge issued to members of the San Antonio Handweavers Guild last fall: Pair up (by random selection) with another guild member. Learn where that individual would like to travel and make a handwoven bag that suits her or his needs. I learned that my On-the-Road-Again partner, Donna, is a world traveler and uses small makeup bags to organize her carry-ons. Likewise, I informed Donna that I like small bags that I can use to hold my travel weaving when Steve and I go camping in our Casita travel trailer. Our guild met last week and we got to unveil our special gifts to each other. I had the smart idea to present the bags nested inside each other. Imagine my surprise when I found that Donna had the same smart idea. What fun!
My contribution for Donna is three small zippered bags, and a linen washcloth to take with her on her travels.
Donna’s thoughtful exchange couldn’t be more perfect – three small zippered bags, and a drawstring bag to hold them all together. I have my band-weaving supplies in the bags, ready for my camping trip with Steve in a few days!
Rag rugs are up next on the Glimåkra Standard. I’m filled with anticipation. Oh, to have the momentum of this hanging beater at my fingertips again. I’m drawn to the simple power of the hanging beater, which is perfect for rug weaving. I already have a place for these rugs in my home once they are woven. So, let’s get going!
First of three bouts. Brick and Bittersweet are wound together, and Unbleached and Umber (a dark green that is almost black) are wound together.I secure the end by pulling a loop up under the wound threads, so I can count the ends of the last group in this bout.Finished winding the third bout. Before cutting off and tying the final pair of ends, I did a visual check of the counted ends at the cross.
The draft is “Den Vackraste” from Älskade Trasmattor, by Hallgren and Hallén, p.87, to which I added some width. I plan to start with a short sample rug to test wefts and check for size. I am winding the 12/6 cotton warp in three bouts. These long, heavy warp chains tell me I’m now on an unstoppable trek that will result in rugs on the floor!
As each bout is wound, I place it in order through the beater, with the tied cross on the other side of the beater.Anticipation!
Until I wind the warp, the rag rugs I’d like to see are merely good intentions. Warp chains placed in order through the beater, though, are a picture of expectation. I have put enough warps on the loom to know with confidence that the rag rugs I anticipate will, indeed, become reality. Faith has that kind of expectation. Faith activates your prayer. The simple power of faith is in believing that the Lord Jesus hears your prayer and that he is able to do what is right for you.
Some things are easier done than said. I said to myself that it’s too much trouble to tie retaining cords on the shafts. I am weaving almost full width on the Glimåkra Julia. I know that heddlescan slip off the ends of shafts. Still, I tell myself I can keep an eye on it. It won’t be a problem, right? Wrong.
Juila’s wide warp. So far, so good. I’ll pay attention and everything will be just fine. Famous last words.Oops. I took this picture after I had fixed most of the mess created by dangling heddles. When heddles slip off shafts they must be put back on thread by thread to maintain correct warp order. These were tangled enough that it took me a few tries to get it right.
Tie Retaining Cords on Shafts
Purpose: Keep Texsolv heddles secure on their shaft bars, especially when weaving a wide warp.
Supplies
Tape measure
12/6 cotton seine twine
Scissors
12/6 cotton seine twine (rug warp) to the rescue!
1 Measure shaft bar from hole to hole. (Julia shaft bar is 70 cm) 2 Figure additional length (about 40 cm) for tying two knots. (70 + 40 = 110 cm) 3 Cut seine twine to measured length for each upper and lower shaft bar. (Heddles can slip off lower shaft bars, too.)
4 Insert one of the seine twine cords through the hole on one end of a shaft bar. Tie. (I use the half-bow slip knot as described in Learning to Warp Your Loom, by Joanne Hall, p.38.)
Tie retaining cord to one end of the shaft bar. Any knot will do, but I like this half-bow slip knot because I can untie it simply by pulling the end of the cord.
5 Insert the other end of the cord through the hole at other end of the shaft bar. Tie.
Thread the cord through the hole at the end of the bar.Tie a simple knot and tighten it.Tie another simple knot, leaving a fold in the end of the cord.Pull the loop to tighten the knot.
6 Repeat steps 4 and 5 for each remaining upper and lower shaft bar.
All tied up and ready to go! When this project is finished I will wind up these retaining cords on an empty tube and re-use them for the next wide warp on the Julia.
Continue weaving with one less thing to think about.
45 minutes: Time it took to reposition heddles that had slipped off a few shafts and were in a mess because I didn’t notice it immediately. Less than 10 minutes:Time it took to cut string and tie retaining cords on 4 upper shaft bars and 4 lower shaft bars.
‘Nuff said.
May you take the time to do what needs to be done.
Remember the rigid heddles for band weaving that Steve made for me? (See Process Review: Heddles and Bands) Soft maple, Spanish cedar, and walnut. Steve says they are missing the “cuteness factor.” So, what does he do? He makes a cowgirl heddle out of cherry that is cute as can be!
Miss Cherry Cutie has a warp of 8/2 cotton and 22/2 cottolin, mixed in an asymmetrical design. Steve converted a little sett tool into a shuttle by bevelling the long edge and carving the sides into curves to hold the wrapped thread.
Well, Miss Cherry Cutie wants to flip over while weaving. A little quilter’s clip on the bottom adds just enough weight. Problem solved. Now Steve wants to make one that has more weight on the bottom half.
Quilter’s clip at the bottom gives Miss Cherry Cutie the balance she needs to stay upright while weaving.Quilter’s clip serves a dual purpose. Besides adding weight for balance while weaving, the clip holds everything together nicely. I can drop this small bundle in a bag, and add a belt and a band lock, and off we go!
Here comes Miss Cutey II in Spanish cedar, with a longer skirt. She doesn’t tip all the way, but she does lean this way and that. The clip helps her, too. Conclusion? The shorter version, with the clip, is more compact and is our favorite design.
Miss Cutie II has a petticoat that hangs below her skirt. This extra length makes her a bit more stable than Miss Cherry Cutie. I cut Miss Cherry Cutie’s warp in half to give Miss Cutie II a warp. These are the same threads, but arranged in a more symmetrical order. She has her own sett tool shuttle, too.Miss Cutie II also benefits from the added weight of a quilter’s clip.
Look who shows up! Miss Cutie III in Spanish cedar. It’s time for a band weaving party, y’all!
Miss Cutie III shows up unexpected. She waits to be threaded with a few ends from the thrums of the Priceless Monksbelt Runner. (See Process Review: Priceless Monksbelt and Video.)Facedown for threading, Miss Cutie III receives the 16/2 cotton threads for her warp. This warp has five doubled pattern threads.Threaded and ready for a 5-thread pick-up pattern.Narrow band, with a subtle zigzag pattern.Back of band has soft floats in triangular shapes.
Persistence comes from having an end in mind. Prayer is like that. We know our heavenly Father hears us when we pray. We know his outcome is good. Faith compels us to persist in prayer. As we do, the Lord guides our heart to align with his will. All the while, he works behind the scenes to bring his answer, which is better than anything.
